Essential Tips on Parquet Floor Sanding

Feb 7, 2024
Essential Tips on Parquet Floor Sanding

Parquet floors have unique decorative patterns that make them stand out from other hardwood floors. Due to their unusual patterns and appearance, it can be hard to figure out the right way to sand them.

To help you out, our experts from Sanding Wood Floors have provided some essential tips on parquet floor sanding to help you sand your floors to perfection and achieve a flawless finish.

7 Tips On Parquet Floor Sanding For A Flawless Finish

1. Assess the Floor for Damage

Before you sand the floors, give them a thorough inspection. Check for damages like scratches, dents, and gaps to help you address the issues later. It will also help you detect protruding nails and other hazards that can hinder the sanding.

2. Ensure You Have The Right Equipment

After you have gauged the floor for signs of damage, gather the tools and material you’ll need to ensure proper sanding. Here is a list of tools you’ll need.

→ Sanders

To sand parquet floors, you need a drum sander and orbital sander for the edges. You can rent the equipment from a trustworthy tool shop near you.

→ Sandpapers

You need different grit sandpapers from higher to lower grit to achieve your desired finish.

→ Cleaning Tools

You’ll need clean clothes, a vacuum cleaner, and a microfiber mop to clean the floor after sanding.

→ Miscellaneous Tools

You also need a hammer, nails, tape, and other essential tools for damage repair.

→ Materials

Apart from the tools, you’ll need spare floorboards, your preferred oil or varnish, and other such materials.

→ Safety Gear

Sanding can be dangerous if you don’t take proper safety measures. So wear goggles, a mask, and shoes to prevent accidents during sanding.

3. Sand in Stages

When sanding parquet floors, avoid sanding in a single go. Instead, divide your sanding into different stages. First, start with the coarsest sandpaper to remove the existing finish and any sanding imperfections from previous sanding.

Then, increase the grit and go over the floor again. Avoid sanding at a 90 ° angle and move the sander at 45° from wood grain for floors with a herringbone pattern. Continue moving the sander around the room while increasing the sandpaper grit until you reach 120 grit.

4. Don’t Forget the Corner and Edges

When you are sanding the floor, don’t forget the edges and corners. Use edge sanders and sand these areas with the same grit sandpaper you use for the entire floor. Stand back and check if the areas look even.

5. Buff the Floor

An extra step to sanding parquet floors is using orbital sanders to remove grooves and ridges from the floor. It will give your floor a smoother finish and prevent the lines from normal sanding.

6. Clean the Excess Dust

Sanding creates a lot of dust, and it’s essential to remove it to maintain your newly sanded floors. While you can opt for dustless sanding, it’s best to vacuum the floor thoroughly from end to end once you finish sanding. Then, mop the area with a clean microfiber cloth to prepare it for finishing.

7. Apply Oil or Varnish

Floor sanding is incomplete without sealing the floor and applying a proper sealant. So, choose the right finish for your floor and start applying it by pouring some on the floor.

Then, use a brush roller to spread the finish. Repeat till you cover the entire floor and let the coat dry. Similarly, apply two more coats to ensure a flawless finish. Avoid walking on the floor while the finish dries, as that can ruin the sanding efforts.

Bottom Line

You can easily sand your parquet floors with these tips. But remember to use an orbital sander after sanding with the traditional drum sander. It’ll help you achieve the desired results for parquet floors and get your desired finish.

Recent Posts